Know Your Dirt Bike Before You Ride

Know Your Dirt Bike Before You Ride

Before you get on a dirt bike for your initial time you should be sure to have the right protection gear including head protection, gloves, goggles, dirt bike pants, for example.

You never need your very first experience on a dirt bike to be a terrible one anytime you could have avoided some sort of problem by simply having on appropriate safety products.

The very first thing you have to learn before you decide to get on the dirt bike is undoubtedly how to start it.

Once you are straddling your dirt bike, before you take a seat on it, you need to put your kick stand up while you’re keeping your bike upright putting both of your hands on the handlebars.

Hold in your clutch and on your right side you will have one particular lever you’ll press all the way down using your foot.

It might not necessarily work the very first try because you may not be sure the power you have to apply to get the engine to start.

Nevertheless, after a few times the bike will start.

READ : How to Maintain Your Dirt Bike

When you get started riding it is important you are aware of exactly where each of the brakes are and how they will operate.

There’s a back break and also a front break which will later possibly be used to get tricks like wheelies.

Your front brake will be along the right side of the handlebar that you simply are going to squeeze, and your rear brake is usually by your right foot where your gear shift should be, however at the opposite side of your bike.

So in the case you are used to operating your bicycle using the rear break by your right hand you have to be cautious due to the fact that when you quickly pull on that front brake while on the dirt bike you are going to get thrown over the bike, assuming you are going fast enough.

If you have ever drove a stick shift in a car, it should help when grasping the way to drive a dirt bike because you will possess the basic notion of how a clutch system operates.

READ : How to clean your dirt bike after a ride

When your bike’s engine is running and you’re all set to get started on riding, along the left side there will be one more lever you press downward using your foot one time, this will set you in 1st gear.

Make sure to have the clutch in the whole time or else the motor will stop running unless it happens to be in neutral.

Rotating the right handlebar is going to give it gas, which you’ll hear by revving your motor.

Give it a little gas and gradually let up on your clutch and you should begin moving forward.

Take notice, that if you let out on your clutch fast and don’t give it sufficient gas, it will probably jerk forward slightly and shut off, alternatively if you ever give it a great deal of gas and then let your clutch out fast, hang on, because you’re going to be off to somewhat of a very fast start.

You’ll sooner or later find the right amount of gas you’ll need to get a steady start.

A nice means of doing that is to hear your engine and how hard it really is functioning.

Finally you know your way around the bike and therefore can certainly learn how to drive it.

READ : How to Minimize Injury When Riding a Dirt Bike

Leave a Comment

Your email address will not be published.